baxter DOSEEDGE - Setting Up the Cart; Installing the UPS and Power Cable; Attaching the Platform

Setting Up the PrepStation Cart
SETTING UP THE PREPSTATION CART
M00205 v1.1 Page 2
SETTING UP THE CART
1. Remove the cover
from the box at the
base of the cart.
2. Insert the UPS in
the rear
compartment of
the box. Thread the
power cable
through the hole in
the base.
3. Do not replace the
cover on the box
yet. Do not plug in
the UPS.
4. Set the platform on
the base so the
screw holes are
aligned.
5. From below, insert
and tighten 5
screws.