baxter EASYSPRAY User Manual

Table 202 - Guidance and Manufacturer’s Declaration - Electromagnetic Immunity
Table 204 - Guidance and Manufacturer’s Declaration - Electromagnetic Immunity
– For Equipment and Systems that are Not Life-Supporting
BAXTER and EASYSPRAY are trademarks of Baxter International Inc., its subsidiaries or
affiliates.
The EasySpray Pressure Regulator is intended for use in the electromagnetic environment
specified below. The user of the EasySpray Pressure Regulator should assure that it is used in such
an environment.
Immunity Test IEC 60601 Compliance Electromagnetic Environment
Test Level Level - Guidance
Electrostatic ±6 kV contact ±6 kV contact Floors should be wood, concrete or ceramic
Discharge (ESD) tile. If floors are covered with synthetic
material, the relative humidity should
IEC 61000-4-2 ±8 kV air ±8 kV air be at least 30%.
Power frequency Power frequency magnetic fields should
(50/60 Hz) 3 A/m 3A/m be at levels characteristic of a typical
magnetic field location in a typical commercial or hospital
IEC 61000-4-8 environment.
The EasySpray Pressure Regulator is intended for use in the electromagnetic environment
specified below. The user of the EasySpray Pressure Regulator should assure that it is used in such
an environment.
Immunity Test IEC 60601 Compliance Electromagnetic Environment
Test Level Level - Guidance
Field strengths from fixed RF transmitters,
as determined by an electromagnetic site
Radiated RF 3V/m 80 MHz 3V/m survey
a
should be less than the compliance
IEC 61000-4-3 to 2.5 GHz level in each frequency range.
Interference may occur in the vicinity of
equipment marked with the following
symbol:
NOTE 1 At 80 MHz and 800 MHz, the higher frequency applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
a. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, Am and FM radio broadcast and TV broadcast cannot be predicted theoretically
with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic
site survey should be considered. If the measured field strength in the location in which the EasySpray Pressure
Regulator is used exceeds the applicable RF compliance level above, the EasySpray Pressure Regulator should
be observed to verify normal operation. If abnormal performance is observed, additional measures may be
necessary, such as re-orienting or relocating the EasySpray Pressure Regulator.
11
G4505_EasySpray_IFU_US_3OK 24.05.2005 15:06 Uhr Seite 11

baxter EASYSPRAY Specifications

General

Brand	baxter
Model	EASYSPRAY
Category	Medical Equipment
Language	English