12
REV 0.9.5
ALARM DEVIATION SETPOINT
If the temperature of the pit deviates above the setpoint by the alarm deviation
setpoint, the alarm will sound and the display will blink COOK TEMP HIGH and
the temperature value.
If the temperature of the pit deviates below the setpoint by the alarm deviation
setpoint, the alarm will sound and the display will blink COOK TEMP LOW and
the temperature value.
The alarm is only allowed once the temperature gets near the cook temperature
setpoint. The alarm deviation is settable from 10-100° F and the factory default
is 50° F.
RAMP COOK AND HOLD
When the ramp is set to on, the low and slow ramp mode is enabled. The ramp
selection tells the control which sensor to ramp from, so the selections are off,
Food1, Food2, Food3. This mode is used for slow cooks so your food (meat)
never over-cooks. This feature will gradually lower the pit temperature to the
food X set point temperature when the food is within approximately 30° of be-
ing done. The controller will hold the pit temperature slightly above your food
set point as long as there is fuel. This feature is similar to cook and hold, but the
PIT TEMPERATURE
Gives “Hi” Alarm
Fit
Setpoint
Gives “Lo” Alarm Time
Deviation Alarm Setpoint
Deviation Alarm Setpoint
TIMEOUT
SELECTION
CONTROL
ACTION
MESSAGE DISPLAYED BEEPER ACTION
NO ACTN
none none none
HOLD
COOKSET is set
to COOKHOLD
value
TIMEOUT HOLD 200° F (or
cook hold temp) Is flashed
continuously until a key is
pressed to clear it.
Sounds once with the number
of beeps set by ALARM BEEPS
ALARM
none TIMEOUT ALARM Is flashed
continuously until a key is
pressed to clear it.
Sounds continuously with
groups of beeps set by ALARM
BEEPS selection until a key is
pressed to clear it.
SHDN
Turns the fan
output off
TIMEOUT SHDN Is flashed
continuously until a key is
pressed to clear it.
Sounds continuously with
groups of beeps set by ALARM
BEEPS selection until a key is
pressed to clear it.
To Next Page
Loading...
