BBQ Guru Cyberq Cloud - Connectivity and Remote Management; Wi-Fi Setup and Hot-Spot Mode

14
REV 0.9.5
to a temperature of 250° F take a minimum of about 20-30 minutes and will also
help to eliminate startup overshoot.
WIFI SETUP SCREEN
To access the Wi-Fi Setup Screen from the MAIN SCREEN display, press and hold
the UP and DOWN keys together for 3 seconds. Navigate to the Wi-Fi SCREEN
using the LEFT/RIGHT arrows. To return to the MAIN SCREEN, press the UP and
DOWN keys together.
For ease of use, we suggest setting up your Wi-Fi
link by following the instructions in section 9. The
interface is much easier to use, and it can be done
from any PC or mobile device equipped with a
web browser.
*** It is important to remember to cycle power
(turn unit off and then on again) after changing
the Wi-Fi settings. They will not be used until
power is cycled. If changing parameters from
a hot-spot or Wi-Fi connection, you can use the
reboot button at the bottom of the web page.
Just as with the main screen, pressing the UP or DOWN Keys will index up and
down through the list of shown parameters as follows:
When WI-FI SETUP is in the top line (with arrow) pressing the LEFT or RIGHT key
will index to the next or previous setup screens (see menu diagram).
Scroll through values in the Wi-Fi SCREEN using the UP/DOWN keys. To modify
a value, press the M/E key. Use the LEFT/RIGHT keys to select the digit to be
modified. Adjust the value with the UP/DOWN Keys. Press the M/E key to save.
To return to the MAIN SREEN, press the UP and DOWN keys together.
8. PAIRING OTHER DEVICES TO THE CYBERQ CLOUD
IN HOTSPOT MODE
The most basic way to use the CyberQ Cloud’s features is by directly pairing it
with one or more Wi-Fi devices in hot-spot mode. While this method doesn’t
enable all the CyberQ Cloud’s features, direct connection can be useful. If you
are at a competition where there is no Wi-Fi or AC power, or if you are tailgating
or camping, for example, taking control with a portable device is handy. Nearly
any device with Wi-Fi capability and a Web browser will work.
If you had previously linked your CyberQ Cloud to another WiFi network in
Infrastruture mode, switch your device back to HotSpot mode. (To switch to
HotSpot mode, hold down the up and down arrows until you get the advanced
menu. Go to the WiFi settings, scroll down to “Load:” and change the setting to
HotSpot. Then unplug your control and plug it back in to restart it.)
WiFi SETUP
192.168.101
GW: 192.168.101
NM: 255.255.255.010
DNS: 192.168.101.010
MODE: AD HOB
DHCP: ON
SSID: XXXXXXX
ENC: WEP40
KEY: XXXXXXX
PORT: 80