25
REV 0.9.5
MANAGE, MONITOR,AND CONTROL
YOUR CYBERQ COUD USING SHAREMYCOOK
For your convenience, there are three ways you can manage the settings on your
CyberQ Cloud: directly on the device using the keys, connecting to it directly
using it as a WIFI access point (called Hotspot mode) and using a browser. You
can also make changes to it through ShareMyCook as long as your CyberQ Cloud
is registered, connected to your home WIFI and connected to the ShareMyCook
website. This uses what is called Infrastructure and Cloud Enabled mode. (Please
refer to the ShareMyCook registration area on how to set this up).
This section describes how to manage your device through ShareMyCook.
1. Click on the ‘Manage’ drop down and select ’My Devices’.
2. You can rename your device from its default name and upload a custom pho-
to as well by clicking on the ‘Edit’ button.
3. If you have multiple ShareMyCook devices, you can choose which device you
want to be your default device by clicking on the ‘Make Default’ button.
4. To manage, monitor, and control your CyberQ Cloud, you should click on the
‘Manage’ button next to the device you want to manage.
5. You will be brought to a new page with four tabs. On each of these four tabs
you will see details: Connection Status and Last Connection from Device.
Connection Status has three options: Good, Intermittent, and OFFLINE. If
your status is good, that means your CyberQ Cloud has a healthy connection
with ShareMyCook. This means the data you see should be recent and it
also means that if you make changes on ShareMyCook, your CyberQ Cloud
is ready to take those changes. If the status changes to intermittent, that
means your connection is not reliable. This usually occurs if your device has
a bad WIFI connection. If the status says offline, that means too much time
has passed since the site heard from the device and your device is considered
disconnected. The most common cause for this is a loss of internet connec-
tion by your CyberQ Cloud. The “Last Connection from Device” status shows
you a time stamp of the last time it received a signal from your CyberQ Cloud.
This is helpful if your device is offline so you can determine when your device
started to have any issues. Depending on the device’s internet connection,
this page usually updates every 15-30 seconds. (Note: When you make chang-
es on these pages for your device, it usually takes 1-2 minutes for the site and
the device to synchronize their information.)
Current Status Page: you can monitor your current temperatures, set your
target temperatures, check on your fan usage, set or check on your timer, and
give names to your food probes. To change any settings, type in the new val-
ues and click ‘Save Changes’. There are certain limits: names of your cook and
food can only be 32 characters long and target temperatures can only be 32
to 475 degrees Fahrenheit. To set your timer, select the desired time from the
drop down from the Set Timer section and click ‘Save Changes’. If you have
a current timer running, it will overwrite it. (Note: when setting the timer
To Next Page
Loading...
