BDE BDE-2007 - Page 26

26
Contents
CHAPTER 1 INTRODUCTION
1-1 Items in Carton --------------------------------------------------------- 1
CHAPTER 2 INSTALLATION
2-1 Best Conditions for Use --------------------------------------------- 1
2-2 Connecting the Load Cell ------------------------------------------- 1
2-3 Front and Rear Panel Dimensions ------------------------------- 2
CHAPTER 3 SPECIFICATIONS
3-1 Analog Input and A/D Conversion --------------------------------- 3
3-2 General ------------------------------------------------------------------ 3
3-3 Rear Panel -------------------------------------------------------------- 3
CHAPTER 4 SYSTEM FUNCTIONS
4-1 System Check -------------------------------------------------------------- 5
4-2 Functions ---------------------------------------------------------------- 5
4-3 Calibration - ------------------------------------------------------------- 9
4-4 System Initialize ------------------------------------------------------- 10
4-5 Accumulation ---------------------------------------------------------- 10
CHAPTER 5 SET POINTS
5-1 Set Points --------------------------------------------------------------- 10
5-2 Batching Modes ------------------------------------------------------ 11
CHAPTER 6 OPTIONS
6-1 I/O Interface ---------------------------------------------------------- 15
6-2 Serial Interface ------------------------------------------------------- 16
6-3 Analog Output -------------------------------------------------------- 19
6-4 Relay control interface OP-08 ------------------------------------ 20
6-5 Modbus ---------------------------------------------------------------- 22