Becker BDC-i440R - Page 39

P. [Unit] Setting
range
Description Ex works
524
0..1
Direction FE2
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This parameter can only be set if P.892 is 1.
0
530
6..29
Function FE3
Selection of the input function for input FE3
13
531 Parameter FE3
Selection of the input profile for input FE3 (parameter depends on input function
configured)
00
534
0..1
Direction FE3
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This parameter can only be set if P.892 is 1.
0
540
6..29
Function FE4
Selection of the input function for input FE4
12
541 Parameter FE4
Selection of the input profile for input FE4 (parameter depends on input function
configured)
00
544
0..1
Direction FE4
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This parameter can only be set if P.892 is 1.
0
550
6..29
Function FE5
Selection of the input function for input FE5
11
551 Parameter FE5
Selection of the input profile for input FE5 (parameter depends on input function
configured)
02
554
0..1
Direction FE5
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This parameter can only be set if P.892 is 1.
0
560
6..29
Function FE6
Selection of the input function for input FE6
8
561 Parameter FE6
Selection of the input profile for input FE6 (parameter depends on input function
configured)
00
564
0..1
Direction FE6
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This parameter can only be set if P.892 is 1.
0
39