Becker BDC-i440R - Page 43

P. [Unit] Setting
range
Description Ex works
634
0..1
Direction FE3 (BDC-XXX M2)
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1 and P.802:1.
0
640
11..29
Function FE4 (BDC-XXX M2)
Selection of the input function for input FE4
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1.
0
641 Parameter FE4 (BDC-XXX M2)
Selection of the input profile for input FE4 (parameter depends on input function
configured)
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1.
00
644
0..1
Direction FE4 (BDC-XXX M2)
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1 and P.802:1.
0
650
11..29
Function FE5 (BDC-XXX M2)
Selection of the input function for input FE5
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1.
0
651 Parameter FE5 (BDC-XXX M2)
Selection of the input profile for input FE5 (parameter depends on input function
configured)
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1.
00
654
0..1
Direction FE5 (BDC-XXX M2)
For setting the direction with two-way traffic control for this input.
0: Inside
1: Outside
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1 and P.802:1.
0
660
11..29
Function FE6 (BDC-XXX M2)
Selection of the input function for input FE6
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1.
0
661 Parameter FE6 (BDC-XXX M2)
Selection of the input profile for input FE6 (parameter depends on input function
configured)
This function is only possible in combination with BDC‑XXX M2 when setting
P.801:1.
00
43