Becker Centronic SunWindControl SWC62 - Group Controller System Wiring

Connection as group controller
Attention
If using as a group controller, no jumpers may be inserted
between the L and C terminals!
1. Connect the power supply unit as follows:
CENTRALSensor
SWC62
L
N
PE
L
N
230 V
L
N
PE
230 V
UC52UC52
green/yellow
blue
black/brown
brown/black
green/yellow
blue
black/brown
brown/black
Tubular drive Tubular drive
CENTRAL CENTRALINDIVIDUAL INDIVIDUAL
Jumper
Jumper
Central-
cable
2. Put the protective caps back on the power supply unit.
3. Fit the power supply unit in the socket.
4. Place the control panel in the frame and insert this into the power supply
unit.
38-en