Becker Centronic SWC441 - What to Do if; General Conformity Declaration

Operating Instructions
19
What to do if ...?
General conformity declaration
Becker hereby declares that the Centronic SunWindControl SWC 441 complies with
the basic requirements and other relevant regulations of the EC Directive 1999/5/
EG.
For use in the following countries: DE, BE, FR, NL, AT, LU, IT, GB, ES, CH, CZ, DK, FI,
HU, NO, PT, SE, IE, GR, PL
Subject to technical changes without notice.
Problem
Cause Remedy
Drive is not functioning,
transmission control
light is not lit.
1. Batteries are dead.
2. Batteries are incorrectly
inserted.
1. Insert new batteries.
2. Insert batteries correctly.
Drive is not
functioning;
transmission control
light is illuminated.
1. Receiver outside the radio
range.
2. Transmitter is not
programmed in the receiver.
1. Reduce distance to the
receiver.
2. Programme transmitter.
Transmission control
light is flashing.
Batteries are running out. Insert new batteries.
Automatic control
commands are not
executed.
Sliding switch not in the
position.""
Set sliding switch to the
position
""
The system is not
extended automatically
when the sliding switch
is set to " ”
1. Sunlight intensity is
below the threshold value.
2. Wind speed exceeds
threshold value
1. Adjust sun threshold value
2. Wait until wind abates
The system does not
extended manually
when the sliding switch
is set to " " or " "
Wind speed exceeds
threshold value
Wait until wind abates