Need help?Do you have a question about the Beckhoff BK5200 and is the answer not in the manual?
General| Product Type | Bus Coupler |
|---|---|
| Bus System | EtherCAT |
| Input Voltage | 24 V DC (-15%/+20%) |
| Current Consumption from E-bus | 100 mA |
| Relative Humidity | 95 %, no condensation |
| Protection Class | IP20 |
| Isolation | 500 V (E-bus/supply voltage) |
| Operating Temperature | 0°C to +55°C |
| Storage Temperature | -25°C to +85°C |
| EMC Immunity/Emission | Conforms to EN 61000-6-2/EN 61000-6-4 |
| Data Transfer Rate | 100 Mbps |
Intended audience, disclaimer, trademarks, patent pending, and copyright information.
Provides detailed safety instructions, warnings, and symbol explanations for users.
Lists modifications and updates for the current version of the documentation.
Introduction to the BK5200 Bus Coupler for DeviceNet, its function and connection.
Introduction to the BK5250 Compact Bus Coupler for DeviceNet, features and capabilities.
Introduction to the LC5200 Low-cost Bus Coupler for DeviceNet, its design and suitability.
Detailed technical specifications for BK5200, BK5210, BK5250, and LC5200 Bus Couplers.
Explains the architecture of the Beckhoff Bus Terminal system, its modularity, and mounting.
Illustrates the principle of the Bus Terminal system with its components and connections.
Introduction to DeviceNet, data exchange, vendor ID, and device groups.
Provides instructions for protecting devices from electrostatic discharge during handling.
Details the physical dimensions and modularity of Beckhoff Bus Terminals.
Guides on mounting Bus Couplers and Terminals on 35 mm mounting rails and disassembly.
Details power supply requirements and potential groups for Bus Couplers and terminals.
Explains electrical isolation features of BK5200/BK5210 and the lack thereof in LC5200.
Details the pin assignment for the 5-pin DeviceNet connector and LC5200 connection.
Specifies DeviceNet baud rates, bus cable lengths, and cable layout.
Outlines special ATEX conditions for use in potentially explosive areas at standard temperatures.
Outlines special ATEX conditions for use in potentially explosive areas at extended temperatures.
Refers to additional documentation for explosion protection according to ATEX and IECEx.
Describes the self-test and start-up process of the Bus Coupler.
Explains how peripheral data is mapped into the process image for inputs and outputs.
Details how to set DIP switches for baud rate and MAC ID configuration.
Explains LED functions, displays, and the function matrix for diagnostics.
Provides an example of input/output channel assignment to the process image.
Information on Beckhoff support, branch offices, service centers, and contact details.
To Next Page
