Beckhoff EL7041-1000 User Manual

Mounting and wiring
EL70x144 Version: 4.4
Terminal housing High Density Housing
Wire size width (single core wires) 0.08 ... 1.5mm
2
Wire size width (fine-wire conductors) 0.25 ... 1.5mm
2
Wire size width (conductors with a wire end sleeve) 0.14 ... 0.75mm
2
Wire size width (ultrasonically “bonded" conductors) only 1.5mm
2
Wire stripping length 8 ... 9mm
4.3.3 Shielding
Note
Shielding
Analog sensors and actors should always be connected with shielded, twisted paired wires.
4.4 Mounting of Passive Terminals
Note
Hint for mounting passive terminals
EtherCAT Terminals (ELxxxx / ESxxxx), which do not take an active part in data transfer
within the bus terminal block are so called Passive Terminals. The Passive Terminals have
no current consumption out of the E-Bus To ensure an optimal data transfer, you must not
directly string together more than 2 Passive Terminals!
Examples for mounting passive terminals (highlighted)
Fig.27: Correct configuration

Beckhoff EL7041-1000 Specifications

General

Brand	Beckhoff
Model	EL7041-1000
Category	Touch terminals
Language	English