What to do if the door will not open on my Beckman Coulter Laboratory Equipment?
If the door of your Beckman Coulter Laboratory Equipment won't open, it might be because the rotor is still spinning. Wait until the rotor stops completely. If the device has no power, plug in the power cord and turn the power on. In case of a source power failure, refer to the section about retrieving your sample during a power failure.
What to do if I see A700 - Imbalance error on Beckman Coulter Laboratory Equipment?
If you are getting an A700 - Imbalance error on your Beckman Coulter Laboratory Equipment, make sure the rotor is installed properly and the rotor load is balanced. Also, ensure the pivot pins and bucket pin pockets are clean and lubricated. If the problem persists, further assistance is needed.
How to fix chamber temperature issues in Beckman Coulter Laboratory Equipment?
If the chamber of your Beckman Coulter Laboratory Equipment isn't reaching the selected temperature, pre-cool or pre-warm rotors before running at low or high temperatures. You can pre-cool the rotor chamber by running a 30-minute cycle at the required temperature with the speed set at 2000 rpm. Ensure the air intake vent is clear. If using multiwell-plates for runs exceeding 2 hours in a warm and/or humid environment, speed reduction may be required to maintain low sample temperature.
How to prevent chamber icing in Beckman Coulter Laboratory Equipment?
To address chamber icing in your Beckman Coulter Laboratory Equipment, wipe out any moisture from the chamber and the chamber gasket before each run. Also, leave the door open between runs, set the temperature to a setting higher than ambient temperature, or turn the centrifuge power off to prevent condensation build-up.
How to fix A301 - Speed error on Beckman Coulter Laboratory Equipment?
To resolve the A301 - Speed error on your Beckman Coulter Laboratory Equipment, confirm that the Set Speed (or Set RCF) is correct.
How to fix A306 - Speed error on Beckman Coulter Avanti J-15 Laboratory Equipment?
To resolve the A306 - Speed error on your Beckman Coulter Laboratory Equipment, confirm that the Set Radius is correct.
What to do if I don't know the program security PIN number on my Beckman Coulter Avanti J-15 Laboratory Equipment?
If you do not know the program security PIN number for your Beckman Coulter Laboratory Equipment, enter the Administrator PIN number in place of the security PIN number to edit or delete the program: 2366
General| Brand | Beckman Coulter |
|---|---|
| Model | Avanti J-15 Series |
| Category | Laboratory Equipment |
| Language | English |
Details general safety measures for operating and maintaining the centrifuge.
Covers high voltage hazards and electrical precautions for safe operation.
Provides guidance on handling hazardous chemicals and biological materials safely.
Explains the power switch, control panel, and digital display interface.
Procedure for performing a centrifuge run with manually entered parameters.
How to create, use, edit, and delete stored programs for automated runs.
Lists diagnostic codes, their definitions, and recommended corrective actions.
Procedures for safely recovering samples during a power outage.
To Next Page