What to do if rotor calibration error in Beckman Coulter Avanti J-26S XP?
Make sure the rotor in use is a compatible Beckman Coulter rotor (see AVAILABLE ROTORS in Section 1). For further assistance, contact Beckman Coulter service.
What to do if there is no rotor installed in Beckman Coulter Laboratory Equipment?
If your Beckman Coulter Laboratory Equipment indicates that there is no rotor installed, or that the drive belt is loose or broken, first install the rotor according to the applicable rotor manual. If the rotor is installed when the message appears, contact Beckman Coulter Customer Service.
What to do if required vacuum level not reached in Beckman Coulter Laboratory Equipment?
If your Beckman Coulter Laboratory Equipment is not reaching the required vacuum level in the allowed time, check and clean the door sealing area and door gasket. Also, wipe any ice and excess moisture from the chamber. If the issue continues, contact Beckman Coulter Customer Service.
Why my Beckman Coulter Avanti J-26S XP cannot maintain temperature?
If your Beckman Coulter Laboratory Equipment cannot maintain temperature: * Check the air filter and replace it if it's dirty. * Contact Beckman Coulter Customer Service.
What to do if the system cannot identify the rotor in Beckman Coulter Laboratory Equipment?
Make sure the rotor in use is a compatible Beckman Coulter rotor (see AVAILABLE ROTORS in Section 1). For further assistance, contact Beckman Coulter service.
What to do if the entered rotor number is not the same as the rotor identified in Beckman Coulter Avanti J-26S XP?
Press [CE] to clear the message and enter the correct rotor entry code.
What to do if required vacuum level is not reached in allowed time in Beckman Coulter Avanti J-26S XP?
Check and clean the door sealing area and door gasket. Wipe any ice and excess moisture from the chamber. For further assistance, contact Beckman Coulter service.
How to prevent Beckman Coulter tube leakage?
To prevent tube leakage in your Beckman Coulter equipment, ensure that caps are properly seated on tubes and fully tightened. Also, make sure all cap components are thoroughly dry before assembly.
Why is my Beckman Coulter bottle leaking (bottles with cap assemblies)?
Leakage in bottles with cap assemblies in Beckman Coulter equipment can occur due to: * Moisture or lubrication on the cap or sealing surface. Ensure the O-ring, plug, and bottle lip are dry and free of lubrication before use. * A damaged or defective O-ring or gasket. Replace the O-ring or gasket. * Insufficiently tightened cap. Tighten the cap securely. * An uneven sealing surface on the bottle. Replace the bottle. * Overfilled tube. If using threaded caps without inserts or O-rings, keep the meniscus lower to prevent leakage.
What to do if adapters stick in Beckman Coulter buckets?
To prevent adapters from sticking in buckets after centrifugation in your Beckman Coulter equipment, apply a thin film of powder, such as talcum powder, to the tube adapter rubber bases after cleaning or as required.
General| Brand | Beckman Coulter |
|---|---|
| Model | Avanti J-26S XP Series |
| Category | Laboratory Equipment |
| Language | English |
To Next Page