How to fix Bedrock Measuring Instruments not recognized by PC?
If your Bedrock Measuring Instruments device isn't recognized by your PC when connected via USB, the issue could stem from a driver problem or the device being in measurement mode. To resolve this, first, update your PC drivers, as the device is approached as a mass storage device. Second, when the dialog window appears on the device screen, select USB data transfer mode.
What to do if Bedrock Measuring Instruments system does not power on?
If your Bedrock Measuring Instruments system fails to power on after pressing the power button, the battery may be empty. Connect the wall charger for at least 30 minutes to resolve this issue.
Why is the battery life too short on my Bedrock Measuring Instruments?
A short battery life in your Bedrock Measuring Instruments device can be due to two main reasons: the battery is not fully charged, or the battery is worn. Ensure the device remains on the charger until it completes its full charge cycle. Note that the battery should be replaced after approximately 500 charge cycles or 4 years.
What to do if Bedrock Measuring Instruments system does not recharge via USB?
If your Bedrock Measuring Instruments system isn't recharging when connected through USB, the charge current may be too low. Use the bundled wall charger and USB cable, as standard PC USB ports might not supply sufficient current for charging.
How to calibrate Bedrock Measuring Instruments battery indicator?
If the battery indicator on your Bedrock Measuring Instruments is inaccurate, it may be due to a poorly calibrated battery charge measurement system, possibly from self-discharge after being shelved for a long time. To fix this, completely drain the battery and then fully recharge it. Repeat this process if necessary.
What to do if Bedrock Measuring Instruments hangs and LED burns red?
If your Bedrock Measuring Instruments device hangs, becomes unresponsive, or won't power up after resetting, and the LED next to the USB port is red, it indicates an internal software problem. To resolve this, keep the power button pressed for 10 seconds to force a shutdown. Then, press the power button again to restart the device.
Why does the Bedrock Measuring Instruments display backlight turn off?
If the display backlight on your Bedrock Measuring Instruments turns off and the touch screen becomes unresponsive, it is likely due to a backlight time-out event. You can adjust the backlight time-out in the power-saving settings. Pressing the power button will turn the display back on.
Why does my Bedrock Measuring Instruments warm up during use?
It's normal for your Bedrock Measuring Instruments device to warm up to around 35C/95F during use. This is usually due to lack of ventilation. If the device becomes considerably hotter, check the ventilation.
General| Brand | Bedrock |
|---|---|
| Model | SM50 |
| Category | Measuring Instruments |
| Language | English |
To Next Page