Bego Miditherm 200 MP User Manual

36
85817 BA-en/12 306.01269…/307.00804…
English ⋅ Miditherm MP
en
Basic principles
Displays after unit is switched on
0…3 sec: parameter of the controller
> 3 sec: current furnace temperature
Furnace care
1. Prior to first use, start program #9
(→ page 41): The furnace heats up to 1050 °C
and maintains this temperature for 60 minutes.
This results in the formation of a protective
oxide layer on the heating wire.
2. Always use the ceramic base.
3. Place the moulds in the chamber so there is no
contact to the walls as far as possible.
NOTE
Remove transport protection device from the
mould chamber prior to start-up!
NOTE
Explanation of the symbols → page 28.
Software

Bego Miditherm 200 MP Specifications

General

Brand	Bego
Model	Miditherm 200 MP
Category	Laboratory Equipment
Language	English