English
⋅
Miditherm MP
41
85817 BA-en/12 306.01269…/307.00804…
Starting a program
1. Switch on the unit. The current temperature of
the furnace is displayed after approx.
3 seconds.
2. Select program:
• Press as often until LED # lights up.
• Press until desired program number
appears.
3. Start program:
Press .
• LED lights up.
• LED "°C” lights up, display shows increas-
ing furnace temperature.
• LED lights up, display shows time of end
of program.
When a holding temperature is reached, the
LED "min" lights up and the remaining minutes
of the holding time are displayed.
4. At the end of the program an acoustic signal
sounds and LED flashes.
• End program (furnace cools down):
press .
• Hold furnace temperature: do not press .
Hazard from shock heat
investment materials: Risk of
injury during shock-heating!
Place all moulds in the furnace within
10 seconds - then keep the furnace
door closed for 15 minutes!
• After program start it takes around 5 minutes
for the furnace temperature to rise.
• Information on next holding temperature: press
(only during heating-up process).
• Turn off acoustic signal after end of program:
open and close furnace door.
• To turn off permanently → page 45.
• After short power failures the program remains
stored and is resumed. Thus, the program can-
not be ended by means of the master switch.
To Next Page
Loading...
Need help?
General
