Service and Maintenance
• If necessary, clean the machine on the outside
with a dry or slightly moist cloth.
• If necessary, sweep out or vacuum-clean the
cooled down mould chamber.
• To burn residues of modelling materials, heat
up the empty furnace to 1050°C regularly every
4 weeks and maintain this temperature for
60 minutes. This is particularly necessary if the
furnace is used exclusively at 700°C.
• Always use the ceramic base.
• Place the moulds in the chamber so there is no
contact to the walls as far as possible.
Warning of electric shock!
Danger to life!
Switch off the machine and pull out
the mains plug before performing any
care or maintenance work.
Do not spray the machine with water
or immerse it in water.
To Next Page
Loading...
Need help?
General
