Behringer FCB1010 User Manual

12
MIDI FOOT CONTROLLER FCB1010
2) If you selected CNT1 or CNT2, you can now enter the number of the controller to be sent (0 through 127)
when you press the corresponding foot switch. After confirming your selection with UP/ENTER you can
now select a controller value (0 through 127). Confirm your selection with UP/ENTER.
+ The EXPRESSION PEDALS require two controller values. If you selected one of these pedals
as the MIDI function to be edited, you can enter the first controller value here, which corresponds
to the lower limit of the parameter range that is sent via MIDI. Please note that the first controller
value must be smaller than the second one!
3) If you selected EXP A or EXP B, you can now enter the controller number the EXPRESSION
PEDAL of your choice is aimed to send values for. Confirm your selection with UP/ENTER and enter the
lower value (pedal up). Confirm with UP/ENTER. Afterwards, enter the upper value (pedal pressed down
completely) and confirm once again with UP/ENTER.
+ You can quit the programming mode at any time by means of a long press on DOWN. Any
confirmed entries will be stored with the currently selected PRESET.
+ How to program the NOTE function is explained in chapter 2.4.4.
2.4 Detailed PRESET programming
2.4.1 Programming PROGRAM CHANGES and SWITCHES
s Select the PRESET you wish to edit.
s Press DOWN for more than 2.5 s to enter PRESET programming mode. The green SWITCH 1/SWITCH 2
LED in the display starts flashing.
s Enable/disable the SWITCHES using foot switches 1 and/or 2 and confirm your selection with UP/ENTER.
The SELECT LED in the display lights up.
s Select the PROGRAM CHANGE item you wish to program (foot switches 1 through 5), by briefly pressing
the corresponding foot switch. The foot switchs LED starts flashing. Please note that the assigned MIDI
function must be enabled for this feature to work. You can enable/disable each MIDI function by means of
a long foot switch press.
s Confirm your selection with UP/ENTER. The NUMBER LED in the display lights up.
s Use the foot switches or EXPRESSION PEDAL A to enter the program change number you wish to transmit
(1 through 128) with the PRESET.
s Confirm your selection with UP/ENTER. The SELECT LED in the display lights up.
s Quit PRESET programming mode by means of a long press on DOWN, or select another MIDI function for
editing.
2.4.2 Programming CONTROL CHANGES and SWITCHES
s Select the PRESET you wish to edit.
s Press DOWN for more than 2.5 s to enter PRESET programming mode. The green SWITCH 1/SWITCH 2
LED in the display starts flashing.
s Enable/disable the switches as needed and confirm your selection with UP/ENTER. The SELECT LED
lights up.
s Select the controller you wish to edit, by briefly pressing the corresponding foot switch (#6 or #7). The
controller must be enabled for this feature to work. The LED of the respective foot switch starts flashing.
s Confirm your selection with UP/ENTER. The NUMBER LED in the display lights up.
s Use the foot switches 1 through 10/0 or EXPRESSION PEDAL A to enter the controller number (0 through
127).
s Confirm your selection with UP/ENTER. The VALUE 1 LED in the display lights up.
2. PROGRAMMING THE FCB1010

Behringer FCB1010 Specifications

General

Type	Controller
Proper use	Concert/Studio
Product color	Black, Grey

Weight and Dimensions

Depth	687 mm
Width	221 mm
Height	60 mm
Weight	4340 g