13
MIDI FOOT CONTROLLER FCB1010
s Use the foot switches 1 through 10/0 or EXPRESSION PEDAL A to enter the controller value (0 through
127).
s Confirm your selection with UP/ENTER. The SELECT LED in the display lights up.
s Quit PRESET programming mode by means of a long press on DOWN, or select another MIDI function for
editing.
2.4.3 Programming EXPRESSION PEDAL A/B and/or SWITCHES
s Select the PRESET you wish to edit.
s Press DOWN for more than 2.5 s to enter PRESET programming mode. The green SWITCH 1/SWITCH 2
LED in the display starts flashing.
s Enable/disable the switches as needed and confirm your selection with UP/ENTER. The SELECT LED in
the display lights up.
s Select the EXPRESSION-PEDAL you wish to program, by briefly pressing the corresponding foot switch
(#8 or #9) and confirm your selection with UP/ENTER. The selected pedal must be enabled for this feature
to work. The LED corresponding to the foot switch starts flashing.
s Confirm with UP/ENTER. The NUMBER LED lights up.
s Enter the CONTROLLER number (0 through 127) using foot switches 1 through 10/0 or EXPRESSION
PEDAL A.
s Confirm your selection with UP/ENTER. The VAL1 LED lights up.
s Use the foot switches 1 through 10/0 or EXPRESSION PEDAL A to enter the MIN. value (this is the value
the FCB1010 transmits when the pedal is up).
s Confirm your selection with UP/ENTER. The VAL2 LED lights up.
s Use the foot switches 1 through 10/0 or EXPRESSION PEDAL A to enter the MAX. value (this is the value
the FCB1010 transmits when the pedal is pressed down completely).
s Confirm your selection with UP/ENTER. The SELECT LED lights up.
s Quit PRESET programming mode by means of a long press on DOWN, or select another MIDI function for
editing.
2.4.4 Programming the NOTE function and/or SWITCHES
The NOTE function allows you to send a MIDI note, for example, to use the tap-tempo features offered by many
MIDI devices.
s Select the PRESET you wish to edit.
s Press DOWN for more than 2.5 s to enter PRESET programming mode. The green SWITCH 1/SWITCH 2
LED in the display starts flashing.
s Enable/disable the switches as needed and confirm your selection with UP/ENTER. The SELECT LED in
the display lights up.
s Briefly press foot switch 10/0 to select the NOTE function. NOTE must be enabled for this feature to work.
The foot switch LED starts flashing.
s Confirm your selection with UP/ENTER. The NUMBER LED lights up.
s Use the foot switches 1 through 10/0 or EXPRESSION PEDAL A to enter the MIDI NOTE number you wish
to send with the PRESET. You can choose from the values 0 through 127. The table below shows which
musical notes are assigned to which MIDI notes (with a detailed list for the octave from C-2 to C-1; simply
use this pattern to assign the remaining notes/octaves yourself).
2. PROGRAMMING THE FCB1010
To Next Page
Loading...
