Output Signals can be freely assigned from any internal signal to any of the following outputs:
8 analog local XLR outputs (with adjustable digital delay for time-alignment of speakers)
8 virtual outputs (marked with *) for routing over AES50 or card outputs
6 auxiliary sends on ¼” TRS outputs
16 channel personal monitoring using the console’s P-16 Bus output connector Any and all of the above signals can also be mirrored
in blocks of 8 signals on either one of
48x channels on AES50 port A
48x channels on AES50 port B
32x channels on USB interface card
Input Channels 1-16 are pre-configured to use the local input signals 1-16, but can be patched to use any other available signal on the
audio engine as well, including mix bus/sub group outputs. Changes of the Channel Source can be made on the Preamp Config page. Input
Channels 17-32 are pre-configured to AES50 A inputs 1-16, so that connecting an S16 stage box to port A will automatically feed the
channels. Aux Return Channels 1-8 are pre-configured to use the 6 aux input signals, and the two USB playback outputs, but can be
patched to use any other available signal of the console as well. FX Return Channels 1L-4R control the 4 stereo output signals of side-chain
FX1-4.
The configuration of Mix Bus Channels 1-16 can be pre-set (in the Setup/Global page) or can also be configured on an individual, per-
channel basis. The bus processing includes (in this order):
Insert point (swappable between post-EQ and pre-EQ operation)
6-band fully parametric EQ
To Next Page
Loading...
