© BEKA 201 All rights reserved5!
...a product of BEKA
Line related errors / warnings:
· Error solenoid valve is missing
· Warning insufficient lubrication
Group related error / warnings:
· Error lubricant pulse monitoring
· Warning line rupture monitoring
· Warning wire rupture monitoring
· Warning cycle pulse monitoring
If more error or warnings are shown, use the control buttons to scroll up or down. Use also the control buttons to scroll up
and down as well as to the right and left.
Press ESC to get out of the error and warning report.
Fig. 23:
The control unit does not differ if the error is related to a sector or sector exceeding and neither in
which section the error has occured.The sorting is done merely acc. to error and warnings. First the
errors are shown, then the warnings.
7.6.5 Read out error and warning report when using a sectional system
The error and warning report can be read out via the display of the control unit or by means of the software BEKA-DiSys
(from version V4.0.8.502).
· Press OK to get into setting mode.
· Use the control buttons to get to menu „error messages“ and confirm with OK.
Fig. 24:
WARNING:
under lubrication
section 1
settings
error messages
*
Note!
20
To Next Page
Loading...
Need help?
General
