Belarus 1025 2008 - Section H. Adjustments; Programming tachometer-speedometer

Belarus 1025/1025.2/1025.3 Section H. Adjustments
H1
Section H. ADJUSTMENTS
Programming tachometer-speedometer
Tachometer-speedometer is programmed by
means of control panel (1) in the following
way:
— Remove cover (4) of the control
panel;
1. Make programming of tachometer-
speedometer according to the
number of pinion teeth where speed
sensor is installed (parameter “z”); to
this end:
— press button (2) on the panel and
input “z” to display (5) of tachometer-
speedometer
— press button (3) on the panel and set
value of the number of teeth (Z) in
accordance with table below:
Number of
teeth (Z)
Tractor model
69
Belarus 1025.2; 1025.3
2. Program radius of rear wheel rolling
(parameter «Rk»):
— press button (2) and enter “Rk” on
tachometer-speedometer display (5).
— Press button (3) and set value Rk
according to table below.
Tire
model
16.9R38
18,4R34
(Ф11)
Rk, m
0.800
0.770
Coded
number
800
770
3. Program diesel model
(parameter «d»);
— press button (2) and enter “d” on
tachometer-speedometer display,
press button (3) and set required diesel
model according to table:
Note: If data on type of tires being mounted
is not available, before putting tractor into
operation one can measure Rk as distance
from wheel axle to the ground. After that
enter to display coded number closest to
value being changed.
Diesel model
Д-245
Д-245 С2
Rated speed,
rev/min
2200
2200
Code
245 or 245С2
Upon programming completion reinstall
panel cover (4)