Belarus 1025/1025.2/1025.3 Section F. Ganging up
F3
Rear mounting mechanism
Three-point mounting mechanism NU-1
(category 2) provides coupling to tractor
mounting and half-mounting agricultural
machinery and implements, having the
following coupling elements:
• length of suspension axle «L» (distance
between joints «А» and «В») equals to
870mm;
• height of machine post equals 61 mm;
(460 mm; 510 mm);
• diameter of suspension axle (pin) for
coupling to joints of lower tie-rods (1 )
equals 28.7 mm for joints 38 or 45 mm
wide;
• diameter of pin for coupling to upper tie-
rod (2) equals 22 mm or 25 mm.
ATTENTION! Carefully study this section
before coupling machines.
Tractors with power control are stocked
with detachable lower tie-rods (1) having
standard length of 885 mm (whole body
or telescopic tie-rods are optional).
Tractors with hydraulic lift are stocked
with telescopic lower tie-rods (1) with
standard length of 885 mm, which can be
changed, if required, within +/- 80 mm
range, by pushing or pulling rear end of
the tie-rod in relation to the front one.
Optionally, these tractors may be stocked
with one-piece lower 885 mm long tie-
rods.
To increase road clearance when tilling
high-stalk plants tractors with power
control can be provided with lower tie-
rods additionally installed on auxiliary
suspension axles, placed 110 mm higher
of the axle of lower tie-rods.
To Next Page
