Care and Cleaning
41
WARNING: ISOLATE COOKER FROM SUPPLY BEFORE REPLACING
LAMP.
Open the oven door and remove the rod shelves. Use a thick cloth to
grip the light glass dome, unscrew anti-clockwise and lift out. Reach
into the aperture with thick cloth, and unscrew the faulty lamp anti-
clockwise (15W 300°C SES). Fit replacement lamp, refit glass lens.
The oven lamp is not covered by the guarantee.
A new lamp may be obtained from our Parts Department by calling:-
01709 579907.
A splashback kit is available as an optional extra from the Belling
Spare Parts Department. For address see separate leaflet.
Care must be taken that Rating Plate edges are not lifted during
cleaning and furthermore that the lettering is not blurred or
removed.
Take care during cleaning not to damage stretch or distort the Door
Seal.If necessary remove the seal by carefully unhooking the corner
clips. Replace the seal after cleaning. Do not use the oven without
the door seal in place.
Using a fine steel wool soap pad to remove stubborn stains from the
rod shelves, meat pan and the floor of the oven. Refer to the
instructions on page 40 for cleaning the ‘Cookclean’ panels.
NEVER use aerosol cleaners on this oven as they could adversely
affect the fan motor unit, and cannot be wiped off the fan blade.
NEVER use steam cleaners.
Replacement of
Oven Lamps
(where fitted)
Rod Shelves &
Meat pan
Splashback
Assembly
N.B.
To Next Page
Loading...
