11
Ka Narrow Band (34.7 GHz) On/Off (LED#3)
When activated, unit will detect ONLY the 34.7 GHz
segment of the Ka bandwidth.
Ka Narrow Band (35.5 GHz) On/Off (LED#4)
When activated, unit will detect ONLY the 35.5 GHz
segment of the Ka bandwidth.
Note: Always operate your unit in Super Wideband
Ka unless you are certain of a specific Ka Narrow
band is used in your area of travel. When engaging
one, two, three or all four Ka Narrow bands,
remember to disengage Super Wideband Ka. If you
do not, the Super Wideband Ka will override any or
all Ka Narrow bands that you have engaged.
Entering Selectable Features Mode
1. With the unit OFF, press and hold the CTY button
followed by the
PWR button. A short “beep” will
sound indicating you’re in Selectable Features mode.
2. Illumination of the appropriated LED confirms feature
is
ON. Conversely, if the selected LED is flashing, the
feature is
OFF.
3. Feature selection is made by pressing the
CTY button
to move forward in the list of Selectable Features;
pressing
DRK moves backward in the list. Selectable
Features appear in the following order and are
identified as follows:
• Auto-Mute — all signal strength
LED’s illuminate.
• SWS — “S”
LED
• X Band — “X” LED
• K Band — “K” LED
• Super Wideband Ka – “Ka” LED
• Ka Narrow 33.8 — first red Signal Strength LED
To Next Page
Loading...
