Appendix D: Save or Cancel
After scanning the data code, scan the "Save" setting code to save the scanned data. If you
make a mistake while scanning the data code, you can cancel the setting.
Save
In the case of a setting, it is also possible to cancel the last hexadecimal scanned. For
example, hexadecimal “A”, “B”, “C” and “D” were scanned in this sequence for a given
setting, but if you scan the code “Cancel previous setting code” the last code scanned “D”
will be canceled.
Cancel a previous setting code
It is also possible to cancel all scanned sequences (“A”, “B”, “C” and “D”) if scanning the
code “Cancel scanned setting codes”.
Cancel scanned setting codes
And if you scan “Cancel Setting” code, the codes scanned will be canceled and the setting
mode will be terminated.
Cancel Setting
To Previous Page
Loading...
