The Code ID character of a specific barcode type can be modified by following steps:
1. Look up the hexadecimal code of the required Code ID character for the barcode
type in the ASCII code character table in Appendix A.
2. Confirm whether programming of scanner is enabled. If not, scan the "Enable
Programming” setup barcode on page 2.
3. Scan the "Code ID" barcode for the barcode type.
4. Scan the data setting bardcodes in Appendix B for the 2 hexadecimal codes of the
Code ID character.
5. Scan the "Save Settings" barcode.
Example, set Code ID of CODE 128 to "A"
1. From the ASCII code character table, the hexadecimal value of the character "A" is
"41".
2. Confirm that programming of scanner is enabled.
3. Scan "CODE 128 Code ID" barcode.
4. Scan the 2 data setting bardcodes "4" and "1" in Appendix B.
5. Scan the "Save Settings" barcode.
To Next Page
Loading...
