Bematech I-500 - Page 41

I-500 Imaging Barcode Scanner
35
PROGRAMMING GUIDE
Transmit entire data
Transmit Start section only
Transmit End section only
Transmit Center section only
To modify length of Start section and End Section, scan the “Modify length of Start
section” or “Modify length of End section” setting barcodes and then scan the data
setting codes to modify the length of the segment. The maximum lengths of the Start and
End segments are 255 characters.
The length of section is represented by a 2 hexadecimal characters that corresponds to
the hexadecimal value conversion of the decimal length value (Table in Appendix A can
be used to look up the data conversion).
Modify length of Start section
Modify length of End section
Abort Setting
Save Settings