D!. "D $% D " $
Description
Use IF…THEN block to execute one or more statements conditionally. Either a single-line syntax or
multiple-line “block” syntax can be used:
MODEL
Syntax
IF condition THEN statement
Note the single-line form of IF …THEN does not use an ENDIF statement.
Or
IF condition THEN (TSPL2 printers only)
Statements
ENDIF
Or
IF condition THEN (TSPL2 printers only)
Statements
ELSE
Statements
ENDIF
Or
IF condition 1 THEN (TSPL2 printers only)
Statement block 1
ELSEIF condition 2 THEN
Statement block 2
ELSEIF condition n THEN
Statement block n
ENDIF
The syntax of IF…THEN…ELSE requires that the command be typed in one single line in
less than 255 characters.
Parameter Description
condition Available relational operator: <, >, =, <=, >=
statement Only one statement is available in
Example
DOWNLOAD "DEMO.BAS"
SIZE 3,3
To Next Page
