% !
Description
This command defines the selective, extra label feeding length each form feed takes, which, especially
in peel-off mode and cutter mode, is used to adjust label stop position, so as for label to register at
proper places for the intended purposes. The printer back tracks the extra feeding length before the
next run of printing.
Syntax
English system (inch)
OFFSET m
Metric system (mm)
OFFSET m mm
Parameter Description
m The offset distance (inch or mm). -1 m 1(inch)
CAUTION: Impropriety offset value may cause paper jam.
Example
English system (inch)
OFFSET 0.5
Metric system (mm)
OFFSET 12.7 mm
See Also
SIZE, GAP, SET PEEL, SET CUTTER
To Next Page
Loading...
