+! ! !
Description
This command feeds the paper through the gap/black mark sensor in an effort to determine the paper
and gap/black mark sizes, respectively. This command references the user’s approximate
measurements. If the measurements conflict with the actual size, the AUTODETECT command will not
work properly. This calibration method can be applied to the labels with pre-printed logos or texts.
Syntax
AUTODETECT [x, y]
Parameter Description
x Paper length (in dots)
y Gap length (in dots)
Note:
(1). If the x, y parameters are ignored then the printer will calibrate and
determine the paper length and gap/black mark size automatically.
(2). When using this command, the printer will detect the label by the proper
sensor type so please don’t set the command GAP or BLINE in your
program.
(3). It is supported in firmware V6.86EZ or later.
See Also
GAP, SIZE, GAPDETECT, BLINEDETECT
To Next Page
Loading...
