16
are unobstructed. To remove small paper particles from the sensors, use a
small brush to wipe off the dust and paper particles. Do not attempt to use
liquids to clean the sensors, in order to avoid damage.
(3) The cutter is manufactured with hardened steel for maximum wear resistance.
It is normal to have some dust buildup in the blades and this will not affect
cutter performance.
(4) Clean the external cabinet with a soft cloth, moistened in water or neutral
detergent. Never use a tow chemically treated or chemical substances like
alcohol or similar solvent. The use of these products can make the cabinet of
the printer changes its color or be deformed.
To Next Page
Loading...
