Bematech LR2000 User Manual

2
1 Introduction
Thank you for purchasing the LR2000 POS printer. Bematech is committed to
continuously improve product quality and provide better after-sales service. In order
to take full advantage of our devices, we strongly recommend that you take the
time to read this manual before diving into software solution.
Note: Information in this manual may change without prior notice.
1.1 Safety Information
 Before plug in the product, please make sure the power you provide meets
the power requirements (such as voltage, frequency); Make sure the ground
terminal of the power outlet is working properly.
 To avoid electric shocks, disconnect the power cord from the electrical outlet
before relocating the system.
 Lightning may damage this product. During lightning storms, unplug the
interface cable, power cable and any other connections.
 Turn off power before connecting any devices (except USB devices and
Ethernet) to the printer.
 Do not attempt to open the chassis. You may be hurt by electric shock. For
service, call your place of purchase.
 Do not spill liquid on the printer. Do not place any objects into the
ventilation holes of this product. It may cause short-circuit of the internal
components and cause a fire or electric shock.
 After the printer is stored below temperature of 10 ° C, please place it in
room temperature (10-35 ° C) in the original packing for at least two hours to
allow the printer to restore to room temperature before operation. This is
to avoid condensation that might cause electrical damage.
 Keep the printer clean, dry, and away from dust, moisture and direct
sunlight.
 Do not use harsh chemicals or strong cleaning solvents to clean the printer.
Wipe it clean with a soft terry cloth applied with a mild solution
 Do not share the same power outlet with high-power electrical appliances;
keep distance from high level magnetic interference.

Bematech LR2000 Specifications

General

Cutter	Yes
Bluetooth	No
Flash memory	- MB
Product color	Black
Maximum resolution	180 x 180 DPI
Autocutter durability	1 million cuts
Operating temperature (T-T)	0 - 50 °C
Mean time between failures (MTBF)	60000000 h
I/O ports	Standard USB Type B, DB9, RJ45, RJ11, 3-pin with latch
USB connector	USB Type-B
Standard interfaces	RJ-11, RJ-45, RS-232, Serial
Serial interface type	RJ-11, RS-232
USB 2.0 ports quantity	1
Connectivity technology	Wired
Maximum roll diameter	710 mm
Supported paper width	79.5 mm
Type	POS printer
Character sets	ASCII
Print technology	Thermal
Operating relative humidity (H-H)	10 - 90 %
AC input voltage	170-240 V
Power source type	AC

Weight and Dimensions

Depth	197 mm
Width	146 mm
Height	149 mm