Bematech MP-2100 TH - Chapter 6 Command Tables; Operation; Vertical Positioning

User’s Manual
18
Chapter 6
Command TCommand T
Command TCommand T
Command T
ablesables
ablesables
ables
Operation
ASCII Dec Hex Description
ESC @ 64 40 Initializes the printer
ESC b n 98 62 Enable (1): Status drawer sensor
Disable (0): Status paper sensor
ESC v n 118 76 Activate drawer (n miliseconds)
-50ms < n < 200ms
ESC w 119 77 Performs a paper cut
ESC x 120 78 Enable Dump Mode
ESC y n 121 79 Enable (1) or Disable (0). Keyboard default (1)
ESC z 1/0 122 7A Enable automatic line feed (n=1). Disable automatic line feeed (n=0)
ESC m 109 6D Performs a parcial paper cut
Vertical Positioning
ASCII Dec Hex Description
ESC C n 67 43 Programs the page size in lines where n is the number of lines
(single height). The standard is 12 lines (of single height).
ESC c n1 n2 99 63 Programs the page size in millimeters where Size=0,125mm*n1*n2.
ESC J n 74 4A Performs the feeding of n*0,125mm of paper.
FF 12 0C Feeds one page.
LF 10 0A Feeds one line.
ESC 2 50 32 Line feed of 1/6” – default line feed
ESC 3 n 51 33 Line feed of n/144 of an inch, where n goes from 18(d) up to 255(d).
ESC f 1 n 102 66 Vertical skipping of n characters.
ESC A n 65 41 Performs the feeding of n*0,375mm of paper.