Bematech MP-4000 User Manual

MP-4000 TH . Revision 1.2
19
25.1. Adjusting the Paper Width
To adjust the paper width simply pull the spacer up and insert it in the desired position,
according to the paper width desired. The figure below helps to identify the correct position, in
compliance with the paper width. Note that for 82.5 mm paper width the spacer is not used at
all. Keep it stored if in the future you will need to change back to a different paper width.
26. Command Set Configuration
In this section you can configure the command set that the printer will recognize when
receiving printer commands from the host system.
You can configure to Bematech or ESC/POS
TM
.
27. Print Mode Configuration
In this section you can configure the Print Mode according to your needs.
You can configure to High Quality or High Speed.
The factory default setting is High Speed.

Bematech MP-4000 Specifications

General

Auto Cutter	Yes
Printing Method	Thermal
Print Speed	250 mm/s
Paper Width	80 mm
Interface	USB, Serial, Ethernet
Connectivity	USB, Serial, Ethernet
Humidity	80% RH