Bemer BEMER-SET PRO - Start-up Procedure - B.BOX; Connection - Applicator Modules; Connecting Application Modules

23
Start-up Procedure – B.BOX
The plug on the power cord is the AC mains disconnect device and must remain readily
operable. To completely disconnect this apparatus from the AC mains, disconnect the
power supply cord plug from the AC receptacle.
Turn the B.BOX over and connect it to the adapter. Place the device on a stable sur-
face and plug the adapter in to the power supply.
A short press on the power button switches the device on, and a longer press will switch it off.
After 2 minutes of inactivity, the device automatically switches off.
Connection of application modules
The two ports, A1 and A2, are available for connecting the application module.
These are not specifically assigned, which means that they can connect any appli cation
module with any port.
The magnetic plug prevents incorrect connection of the application module.
Connection – Applicator Modules
1960-2002-BEDIENANL-B.BOX-USA-FDA-2020-US-en-v13-Akku Rev20_4.indd 231960-2002-BEDIENANL-B.BOX-USA-FDA-2020-US-en-v13-Akku Rev20_4.indd 23 04.11.2020 08:47:2804.11.2020 08:47:28