Bemer BEMER-SET PRO - Default Settings - using the B.BOX Professional; Setting Plus Signal Default; Setting Intensity Default; Setting Signal Volume

28
The parameters [PLUS] and [INTENSITY]
can be adjusted to be the default setting.
Setting the plus Signal as default
• To switch the plus Signals on/off, press the
[PLUS] button before starting the program.
Setting the intensity to HIGH / LOW
as default
The B.PAD can be used for program treat-
ment and treatment by Basic Plan.
• Press the [SET] button.
• Press the [HIGH/LOW] button. When
pressed, the button switches from [HIGH]
to [LOW] and vice versa.
Setting the signal volume
• Press the [SET] button.
• Press the [VOLUME] button.
• Set the desired signal volume with
the help of the arrow keys.
• The selection is always acknowledged
by a signal at the chosen volume.
• Press the [SAVE] button to save
your settings.
Confirmation of the [SET]
button is possible only if
no application is active.
Default Settings – application parameters / Basic settings – B.BOX Professional
1960-2002-BEDIENANL-B.BOX-USA-FDA-2020-US-en-v13-Akku Rev20_4.indd 281960-2002-BEDIENANL-B.BOX-USA-FDA-2020-US-en-v13-Akku Rev20_4.indd 28 04.11.2020 08:47:2904.11.2020 08:47:29