39
ERROR MESSAGE CAUSE TROUBLESHOOTING
ERROR 1 An active applicator has been removed during the
application.
Reconnect the applicator and start the application again.
ERROR 2 The temperature of the product is too high. Check the environmental conditions and let the product
cool down. When in doubt, contact service.
ERROR 3-4 There is a problem with the applicator module. Please contact service.
ERROR 5-6 There is a malfunction of the power supply. Please check for the possible sources of error such as:
the power supply, the vehicle connection cable (12 volt)
or the rechargeable battery (see technical data). When in
doubt, contact service.
ERROR 7-8 There is a malfunction of the control unit. Please contact service.
ERROR 9-12 There is a malfunction of the applicator module. Please contact service.
ERROR 101 There is no applicator connected. Please connect an applicator to the product.
ERROR 104 An unknown applicator has been detected. The applicator module is invalid; please contact service.
ERROR 105 The capacity of the battery is too low. The battery is empty; recharge the battery by connecting
to the power supply.
ERROR 108 Chipcard cannot be read properly. Please contact service.
For error messages that are not described here, please contact service.
1960-2002-BEDIENANL-B.BOX-USA-FDA-2020-US-en-v13-Akku Rev20_4.indd 391960-2002-BEDIENANL-B.BOX-USA-FDA-2020-US-en-v13-Akku Rev20_4.indd 39 04.11.2020 08:47:3104.11.2020 08:47:31
To Next Page
Loading...
