Bemer Set Classic Pro - Page 133

133
 DEUTSCHENGLISH 
   
ERROR 1 An active applicator has been removed during the application. Reconnect the applicator and start the application again.
ERROR 2 The temperature of the device is too high. Check the environmental conditions and let the device cool down.
When in doubt, contact service.
ERROR 34 There is a problem with the application module. Please contact service.
ERROR 56 There is a malfunction of the power supply. Please check for the possible sources of error such as:
the power supply / the vehicle connection cable (12 volt) or the rechargeable
battery (see technical data). When in doubt, contact service.
ERROR 78 There is a malfunction with the control device. Please contact service.
ERROR 912 There is a malfunction of the application module. Please contact service.
ERROR 101 There is no applicator connected. Please connect an applicator to the device.
ERROR 104 An unknown applicator has been detected. The applicator module is invalid, please contact service.
ERROR 105 The capacity of the battery is too low. The battery is empty, recharge the battery by connecting
to the power supply.