Bemer Set Classic Pro - B.BOX Classic Settings - Parameters

108
: :    . 
Default settings – application parameters / basic settings– B.BOX Classic
Default setting signal intensity
(only with the B.PAD)
While traveling, the B.PAD can be
used as a substitute for the B.BODY
by reducing the intensity to [LOW].
>> Select the menu item [INT] in the
settings menu using the arrow keys
and confirm with [SET].
>> By using the arrow keys you can
choose between [HIGH] (high in-
tensity) and [LOW] (low intensity).
>> Once the selection has been made,
confirm with [SET].
The parameters [PLUS] and [INTENSITY] can be ad-
justed to become the default setting in the settings
menu. To access this menu, press and hold down
the [SET] key. You can select the parameters [PLUS]
or [INTENSITY] by using the arrow keys. To exit the
menu, select with the arrow keys [EXIT] and confirm
with the [SET] key.
Setting the plus Signal as default
>> In the settings menu, select the menu item [PLUS]
with the arrow keys and confirm with [SET].
>> By using the arrow keys, the plus Signal can be
switched on / off.
>> Once the selection has been made, confirm with
[SET]. Now the plus Signal has been swtiched on or off.
Setting the signal volume
>> Press and hold down the [SET] key to
activate the settings menu.
>> With the arrow keys, select [VOLUME]
and confirm with [SET].
>> Then choose the desired signal volume
by using the arrow keys.
The selection will always be acknowledged
with a signal in the chosen volume.
>> Confirm selection with [SET].