1268-600
VARIABLE SPEED JIGSAW
16
Fig. 12
1
MATERIALS YOU CAN CUT
materials. Some of these materials include:
• Wood products such as lumber, hardwood, plywood,
composite board, and panelling
• Drywall
• Styrofoam
• Fibre board and plastic
• Metals such as pipe, steel rods, sheet steel, aluminum, brass, and copper.
NOTE:
metal cutting blades (fine teeth) and wood cutting blades (coarse teeth). Use the
correct blade for your application. The packaging on the blade will indicate the type
of materials each blade is designed to cut.
WARNING: For safety reasons, the operator must read the sections of
this Owner’s Manual entitled “GENERAL SAFETY WARNINGS”, “POWER
TOOL SAFETY”, “SPECIFIC SAFETY RULES”, “EXTENSION CORD SAFETY”
and “SYMBOLS” before using this jig saw.
Verify the following every time the jigsaw is used:
1. The blade is sharp and in good condition.
2. The blade is firmly clamped into the blade holder.
3. The workpiece is properly secured.
4. Safety glasses and hearing protection are being worn.
Failure to observe these sa
fety rules will significantly increase
the risk of injury.
GENERAL CUTTING
1. Clearly mark the workpiece to locate the position of the cut.
2. Hold smaller workpieces with a vice.
Clamp larger workpieces to a workbench or table.
DANGER: Any workpiece that is not adequately clamped in place may come
loose and cause serious injury. Never hold the workpiece with your hand.
WARNING: Keep your hands and fingers away from the motor housing and
the blade holder. Do not reach underneath the workpiece while
the jig saw is running.
To Next Page
Loading...