Benchmark TD-550 - Warranty

TD-550/560 Oil in Water Analyzer Warranty
PN 106737
REV H
TD-550/560 Oil in Water Analyzer
Operation Manual
31
8 WARRANTY
This section details warranty services and legal provisions regarding the product and its documentation.
8.1 COPYRIGHTS
All rights reserved. This document contains proprietary information of Benchmark International,
Edmonton, Alberta, Canada, embodying condential information, ideas, and expressions. No part of this
document may be reproduced or transmitted in any form or by any means, electronic, mechanical, or
otherwise, without prior written permission from Benchmark International.
8.2 TRADEMARKS
TD-550, TD-560, TD-120, E09 TD-4100XD, E09 TD-4100XDC, TD-4100XD, TD-4100XDC and TD-107
are trademarks of Benchmark International.
Other brand and product names are trademarks and/or registered trademarks of their respective
holders.
8.3 RIGHT OF CHANGE
Information in this document is subject to change without notice and does not represent a commitment
on the part of Benchmark International.
For questions or comments about this manual, please contact:
Benchmark International, Inc.
Service Department
5304 36 Street NW, Edmonton, AB, Canada T6B 3P3
Email: service@oilinwatermonitors.com
Website: www.oilinwatermonitors.com
8.4 LIMITED WARRANTY
All Benchmark International products are manufactured under strict quality control to the highest
standards available. It is our intention to provide the fastest response to any potential warranty service
requirement.
What We Cover
Benchmark International warrants its monitors and accessories to be free from manufacturing defects
under normal use and with proper installation and maintenance as dened in the Operation and
Maintenance Manual and as advised by Benchmark International, for a period of one year (12 months)
from the date of shipment. An extended warranty is available at an additional cost for a total not to
exceed 3 years (36 months) from date of shipment. The extended warranty must be purchased prior to
shipment.
If your monitor or monitor component becomes defective due to a manufacturing defect within one year
of shipment, Benchmark International will repair or replace at our sole option your monitor or component
free of charge at our factory, Edmonton, Alberta, Canada. All freight charges, insurance, customs duties
and clearance fees, inland freight and handling fees from third parties to and from the factory are not
covered by this warranty.
All costs for removal, re-installation and for re-calibration of the monitor are not covered under warranty
and are the responsibility of the purchaser or customer.