Bend-Tech DRAGON A150 - Page 44

Bend-Tech DRAGON A150

78 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

44 Bend-Tech Dragon A150

Troubleshooting Guide

Gate

08

Table of Contents

Customer Service5
Customer Satisfaction Commitment5
Warnings6
Glossary8
- Table of Contents9
Contents10
Introduction13
- Dragon A150 Manufacturing Differences13
  - How to Send a Support Session14
Cutting Issues15
- Cut Rotation and Backlash Correction16
Toolhead23
- Adjusting the Toolhead Trolley24
- Remove the Toolhead24
- Toolhead Rail25
  - Leveling the Toolhead Rail25
- Toolhead a Axis Mounting26
  - Method 126
  - Method 226
- A Axis Drive Motor Set Screws27
Torch29
- Mounting the Torch30
- Routing the Torch Lead30
- Grounding the Torch31
- Setting Torch Dwell Time32
- Torch Relay32
Engraver35
Marker37
Laser39
- Control Box Laser Connection39
- Laser Replacement40
Gate41
- Gate Wear42
- Gate Maintenance42
- Gate Removal42
Trolley45
- Trolley Adjustment45
  - Adjusting the Trolley46
  - Removing the Trolley Cover47
- Limit Switch47
  - Replacing the X Limit Switch47
Chuck49
- Chuck Overview49
And y Axis Maintenance51
- And y Axis Maintenance and Adjustment51
- Set Screw and Chain Maintenance52
  - Gear and Chain Adjustment52
- Backlash Correction53
- Additional Trolley Set Screws54
- Chuck Alignment54
  - Aligning the Chuck54
Center Support Lift57
- Center Support Lift Air Cylinder58
  - Center Support Lift Air Pressure Setting58
  - Center Support Lift Actuation Switch58
Control Box59
- Accessing the Control Box59
- Main Power Fuse60
- Accessing Control Box Internals60
- Gecko Drive LED Lights60
- Gecko Drive Issues60
- Gecko Drive Fault Code60
- Adjusting the Gecko Drive61
- Replacing the Gecko Drive61
Operator Control Panel63
- Reading ESS LED Status Codes63
  - Ethernet Jack LED Lights64
- Ethernet Cable and Connections65
Limit Switch Operation67
- Troubleshooting Limit Switches68
- Machine Control and Mach3 Indicate Homing Switch Is Triggered68
- And a Axis Limit Switch Failure69
  - Replacing the a Axis Limit Switch69
  - Replacing the X Limit Switch70
Mach373
- Mach3 Machine Driver Software73
  - Installing Warp 9 Utility73
  - Prioritizing Mach on the Computer73
- Other Mach3 Errors73

Other manuals for Bend-Tech DRAGON A150

Original Instructions32 pages

Related product manuals

Bend-Tech Dragon