Autostacker™ Parking Lift 53 P/N 5900002 — Rev. D — August 2019
Positioning the Bottom Connector Tube
If you want to position the Control Stand at the
Rear
end of Lift (the Drive-up end), make sure the
Window for routing the Control Stand wires through the Bottom Connector Tube is on the same side
of the Lift where the Control Stand will go.
If you want to place the Control Stand at the
Front
of the Lift, continue to the next section.
The Window for the Control Stand wiring can go on either side of the Lift, as long as the small gap on
the Bottom Connector Tube (from the top Bolts to the top of the Tube) remains at the top and the
large gap (from the bottom Bolts to the bottom of the Tube) is at the bottom, as shown below.
The Power Unit must also be near the Front of the first Lift (the Lift closest to the Power Unit); it can go
on either side of your setup, up to 30 inches away.
The following drawing shows the general arrangement for the Bottom Connector Tube.
To Next Page
Loading...
