GrandPrix (GP-7 Series) Two-Post Lifts 48 P/N 5900209 — August 2018 — Rev. C2
Raising the Lift
This section describes how to raise a vehicle on the lift.
⚠ WARNING: Never raise a vehicle whose weight exceeds the rated capacity of the lift. Do not
leave the controls until the lift is on a Safety Lock.
To raise a vehicle:
1. Make sure the arms are on the ground in their full drive-thru position.
2. Drive the vehicle in.
⚠ CAUTION When driving a vehicle into position, keep to the middle of the area between the
posts. If you hit any portion of the lift, you could damage the vehicle and/or the lift.
3. When you are satisfied with the location of the vehicle, put it in park, put on the parking brake, and
turn off the motor.
If the vehicle is a manual transmission, put it into first gear before turning off the motor.
4. Get out of the vehicle; open the doors carefully to avoid banging them on the lift.
5. Adjust the lift arms under the vehicle so that the pads have secure contact with the vehicle’s lifting
points and the vehicle is balanced on the pads.
If necessary, use the included adapters.
6. Push in and hold the Up Pushbutton (on the Power Unit near the top).
To Next Page
Loading...
