BendPak SP-7X User Manual

1
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF
THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
REV C 08-20-089
p/n 5900109
7,000 POUND CAPACITY
FULL-RISE
SCISSORS LIFT
MODEL: SP-7X
Keep this operation manual near the
machine at all times. Make sure that
ALL USERS read this manual.
SHIPPING DAMAGE CLAIMS
When this equipment is shipped, title passes to the
purchaser upon receipt from the carrier.
Consequently, claims for the material damaged in ship-
ment must be made by the purchaser against the trans-
portation company at the time shipment is received.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
www.bendpak.com
BE SAFE
Your new lift was designed and built with safety in mind.
However, your overall safety can be increased by proper
training and thoughtful operation on the part of the
operator. DO NOT operate or repair this equipment with-
out reading this manual and the important safety instruc-
tions shown inside.
INSTALLATION AND OPERATION MANUAL
INSTALLATION AND OPERATION MANUAL

BendPak SP-7X Specifications

General

Brand	BendPak
Model	SP-7X
Category	Lifting Systems
Language	English

Summary

Introduction and Safety Warnings

General Warnings and Cautions

Provides essential warnings and cautions before operating the lift.

Installer and Operator Guidelines

Installer/Operator Agreement and Responsibilities

Agreement confirming understanding of installation, operation, and potential risks.

Safety Instructions for Operation

Essential Safety Precautions

Comprehensive list of safety rules for operating the lift.

Installation Site and Requirements

Site Selection and Floor Requirements

Criteria for choosing a suitable installation site and floor specifications.

Step 3: Anchoring the Lift Frames

Drilling and Preparing Anchor Holes

Instructions for drilling and cleaning anchor holes in the concrete.

Installing Anchor Bolts and Shims

Steps for inserting and tightening anchor bolts with shims.

Step 6: Power Unit Electrical Hook-Up

Electrical Wiring Requirements

Instructions for connecting the power unit to the electrical supply.

Wiring Diagram and Safety Notes

Step 7: Lift Start-Up and Checks

Lift Initial Start-Up Procedure

Post-Installation Operational Checklist

Step 8: Lift Operation and Maintenance

Vehicle Lifting and Lowering Procedures

Step-by-step guide for safely lifting and lowering vehicles.

Lift Operation Safety Guidelines

Detailed Vehicle Lifting/Lowering

Lift Capacity and Safety Labels

Maximum Lifting Capacity Specifications

Details the maximum weight capacity for the lift and axles.

Safe Lift Operation Procedures

Operator Training and Preparation

Key Lift Operation Safety Rules

Essential safety rules for operating the lift with vehicles.

Critical Operational Prohibitions

DO NOT Actions During Operation

Lists critical actions that must not be performed while operating the lift.

Troubleshooting: Lift Will Not Raise

Possible Causes for Lift Failure

Identifies common causes when the lift fails to raise.

Remedies for Lift Not Raising

Troubleshooting: Motor and Lowering Issues

Motor Not Running Causes and Remedies

Diagnoses and solutions for the motor not running.

Slow or No Lowering Causes

Troubleshooting: Loaded Lift Issues

Causes for Loaded Lift Not Raising

Common causes when the lift cannot raise a loaded vehicle.

Remedies for Loaded Lift Failure

Troubleshooting: Lift Will Not Stay Up

Causes for Lift Not Maintaining Height

Identifies reasons why the lift might lose pressure or descend.

Remedies for Lift Descent Issues