XPR-10 Series Two-Post Lifts 35 P/N 5900951 — Rev. D — May 2019
9. Plumb each Post; install any needed Shims or the optional Adapter Trays (which let you stack the
provided Auxiliary Adapters — also called Extenders — conveniently near the Lift Arms).
Tip If you are going to torque the Anchor Bolts later so that installing the Overhead Assembly
and doing final leveling is a little easier, skip the next step. Instead, make sure the Anchor
Bolts are securely in position; you do not want the Posts moving too much during the
rest of the installation procedure.
10. Wrench each Nut
clockwise
to the recommended installation torque, 110 – 150 foot pounds,
using a Torque Wrench.
Important: Do
not
use an impact wrench to torque the Anchor Bolts.
Wrenching the Nut forces the Wedge up, forcing out the Expansion Sleeve and pressing it tightly
against the Concrete.
To Next Page
Loading...
