BendPak XPR-10 Series - Page 37

XPR-10 Series Two-Post Lifts 37 P/N 5900951 — Rev. D — May 2019
The following drawings shows the Bolt/Washer/Nut locations for both Narrow and Wide
Configurations for Symmetric and Asymmetric models.
Symmetric
Asymmetric
Note: When you line up the two Overhead Assembly pieces together, there will be four holes
that go through both pieces. Two holes on each side of the Overhead Assembly.
4. Put the Safety Shutoff Bar in place in the desired configuration.
If you are switching the Safety Shutoff Bar from Narrow to Wide Configuration, loosen the Slider
Stops, adjust the Safety Shutoff Bar appropriately, then re-tighten the Slider Stops.
The following drawing shows the components on the Safety Shutoff Bar.