BendPak XPR-10 Series - Page 51

XPR-10 Series Two-Post Lifts 51 P/N 5900951 — Rev. D — May 2019
11. Switching to the Offside Post , take the Long Hydraulic Line and route it over the Overhead
Assembly towards the Powerside Post.
12. Make sure to put the Line through the Clips in the Posts and in the Overhead Assembly as you
route the Long Hydraulic Line.
13. If you are installing the Lift in a
Wide Configuration, you need to install the Very Short Hydraulic
Line to the top of the Tee Hydraulic Fitting, and then install a Nipple Hydraulic Fitting (04 JIC to 04
JIC) to the top of the Very Short Hydraulic Line. Make sure to securely tighten each connection.
The Very Short Hydraulic Line is
not used for Narrow Configurations .
Not all components shown. Some components exaggerated for clarity.
14. Connect the Straight End of either the Long Hydraulic Line (for Narrow Configurations) or the Very
Short Hydraulic Line (for Wide Configurations) to the 04 JIC connector facing up on the Tee
Hydraulic Fitting; finger tighten the connection.
15. Using appropriate tools, securely tighten all of the finger-tightened connections.